- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: Grove - TB6612FNG - 12 V / 1.2 A dual channel motor controller
This module from Grove series is equipped with a two-channel TB6612FNG bridge, which communicates via I2C bus with for example Arduino. System allows to control direction ofrotation ofmotors with maximum current consumption up to 1.2 A and supply voltage up to 12 V. The module allows you to control two direct current (DC) motors or one stepper motor at a time. It has a digital output, which makes it compatible with most commissioning modules in cluding Raspberry Pi and Arduino.
Grove Controller Features - TB6612FNG
- Equipped with MCU
- CW / CCW / short brake / stop operating modes
- Built-in thermal switch and low voltage detection circuit
- Standby (power saving) system
Arduinocompatible product
The manufacturer has prepareduser guidefor Arduino as well aslibrary with sample code.
Grove - TB6612FNG - 12 V / 1.2 A dual channel motor controller.
Connection of Grove - TB6612FNG controller.
Connection of Grove controller - TB6612FNG
This module is equipped with Grove interface which makes it easy to connect it to Arduino with Base Shield v2.0 or Raspberry with Grove Pi+Hat.
| Pin | Description |
|---|---|
| GND | System ground. |
| SCL | I2C bus clock line. |
| SDA | I2C bus data line. |
| VCC . | Supply voltage: 3.3 V to 5 V. |
| VM | Motor power supply. |
| I2C | Bidirectional bus. |
|
A (1-2) B (1-2) |
Dual channel DC motor output. |
|
OUT (1-4) |
Stepper motor control. |
Technical specification of the Grove Controller - TB6612FNG
| Attribute | Value |
|---|---|
|
Operating voltage |
3.3 V / 5 V |
|
Motor supply voltage |
2.5 V ~ 13.5 V |
|
Input tolerance |
5,5 V |
|
Output current |
1.2 A rated 3.2 A momentary |
|
Switching frequency |
100 kHz |
|
Operating temperature |
from -40°C to 85℃ |
|
Interface |
I2C |
|
I2C address range |
0x40 ~ 0x7f (default) |
|
Dimensions |
13 x 60 x 40 mm |
Useful links |
