- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description of product: Grove - sensor of DC ACS70331 - 2.5 A
Popular current sensor ASC725 on the basis of thetechnology MGR (magnetoresistive effect). This technology is characterized primarily by very high sensitivity which can be even 25 times bigger than in the sensors based on the Hall effect. This model was manufactured by Seeed Studio and is equipped with a standardGrove interface that greatly facilitates the use of the sensor in cooperation with Arduino and Raspberry Pi through Grove Base Hat. The connection of electricity for measurement is through a simplescrew clamp. The sensor, to operate, has to have a power supply of3.3 V or 5 Vand it can measurecurrent of up to 2.5 A at a voltage of up to 100 V.
Design of the DC sensor Grove ACS70331 - 2.5 A
 |
SIG:the analog output, it sends the actual value to the MCU |
 |
NC:not connected |
 |
VCC:5 V or 3.3 V voltage for this module |
 |
GND:connecting the module to the ground |
 |
electrical connection to measure (minus) |
 |
electrical connection to measure (plus) |
|
Specification of the DC sensor Grove ACS70331 - 2.5 A
- Supply voltage: 3.3 V / 5 V
- Working voltage: <100 V
- The detection range of current: from 0 A to 2.5 A
- Base sensitivity: 800 mV/A
- Output interface: analog
- Input interface: screw clamp
- Ambient temperature during operation: -40°C to 85°C
- Storage temperature: -65°C to 125°C
Useful links |
