Product description: GPS-RTK HAT module with GNSS ZED-F9P system - overlay for Raspberry Pi - SB Components 25961
GPS-RTK HAT from SB Components is an advanced GPS module that offers 10 mm of three-dimensional accuracy thanks to the ZED-F9P chip from u-Blox. This module supports four GNSS constellations : GPS, BeiDou, Galileo and GLONASS, which allows you to receive signals from multiple sources simultaneously, increasing the accuracy and reliability of positioning. Thanks to built-in anti-jamming and anti-spoofing functions, and the ability to work in RTK mode, GPS-RTK HAT ensures fast and precise positioning with minimal drift. The module also supports positioning assistance systems such as SBAS, QZSS, IMES and D-GPS , and A-GNSS technology, which speeds up initial positioning. The module is also equipped with four LEDs to indicate status and a USB Type-C connector for easy configuration using the U-Center software.
GPS-RTK HAT module with GNSS ZED-F9P system - overlay for Raspberry Pi - SB Components 25961.
The module supports fast RTK positioning.
Special features of the module
- Horizontal position accuracy : 2.5 m without RTK and 0.01 m with RTK.
- Supports simultaneous reception of four GNSS systems : GPS, BeiDou, Galileo, GLONASS.
- Maximum speed : 500 m/s.
- Maximum altitude : 50 km.
- Reception of bands : L1C/A and L2C.
- 4 LEDs: for monitoring module status.
- U-Center support : a simple way to configure the module.
- RTK : multi-band support, fast convergence times, centimeter-level precision, high update rate.
- Compatibility with various platforms: Raspberry Pi, Rock SBC, Jetson Nano, Banana Pi and others.
Applications of the GPS-RTK module
GPS RTK HAT is widely used in areas requiring precise positioning and navigation. It can be used in autonomous vehicles for accurate navigation, in drones for flight planning, in surveying for precise mapping of areas, and in IoT projects where high location precision is required.
Supports boards from the Raspberry Pi, Rock SBC, Jetson Nano, Banana Pi and other series with a standard 40-pin GPIO expansion connector.
Arrangement of elements on the board
- SMA connector
- Battery basket
- LED indicators
- USB Type-C connector
- Pin INT
- Additional LED pins
- Level switch
- Power pins
- UART interface
- I2C interface
- UART2 interface
Technical specifications of the module
- Module type: GPS RTK
- GNSS Compatibility: BeiDou, Galileo, GLONASS, GPS/QZSS
- Number of simultaneous GNSS: 4
- GNSS band: B1I, B2I, E1B/C, E5b, L1C/A, L1OF, L2C, L2OF
- Interfaces: 2x UART, USB C, I2C, SPI
- Supply voltage: 2.7V to 3.6V
- Navigation sensitivity: -167 dBm
- Output power: from 18 dBm to 26 dBm
- Antenna open circuit detection: yes
- Antenna short circuit detection and protection: yes
- RTK rover function: yes
- RTC clock: yes
- Safe start: yes
- Operating temperature: from -40°C to 85°C
- Dimensions: 56.76 x 53.75 mm
Set contents
- 1 x GPS RTK HAT
- 1 x GNSS Antenna
The GPS RTK module allows you to determine your position, direction and route in less than 30 seconds.
