Product description: Gravity - analog current measurement sensor - STK-600/M V2 - 50A DC/AC - DFRobot SEN0098-V2
Analog Gravity current sensor from DFRobot , whose task is to monitor and protect the circuit of your project. Thanks to the use of the Hall effect, it ensures precise measurement of both alternating and direct current up to 50 A. The copper conductor protects the device even in the event of a short circuit. It can generate an analog voltage signal that varies linearly with the detected current. The module's pins are soldering pads and through-hole connectors, which enable soldering of thick electric cables and T-shaped connectors. The board also has a connector compatible with the Gravity standard. The current sensor has functions of increased heat dissipation and circuit protection, which can be helpful in motor control or load detection.
Gravity - analog current measurement sensor - STK-600/M V2 - 50A DC/AC - DFRobot SEN0098-V2.
Analog Gravity current sensor from DFRobot, whose task is to monitor and protect the circuit of your project.Special features
- Compatible with T-shaped plug
- Possibility to measure alternating and direct currents
- Hall current sensor
- Isolated measurement
- Immunity to magnetic wire interference
Application
- Motor control
- Load detection and management
- Aeronautical modeling
- Detection of too high current in devices
Technical Specifications
- Supply voltage: 5V
- Signal type: analog
- Built-in chip: STK-600/M
- Maximum voltage during measurement: 50 V AC / 120 V DC
- Current measurement range: - 50 A to 50 A
- Signal bandwidth: 120 kHz
- Response time: 4.6 μs
- Operating temperature: from -40°C to 125°C
- Sensor dimensions: 32 x 42 mm
Set contents
- Gravity current measurement sensor
- Gravity Cable
The input and output are designed as through-hole holes and slots, allowing soldering of thick electrical wires and T-shaped connectors. Useful links |
