- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: Wio Lite MG126 - ATSAMD21 Bluetooth
Wio Lite MG126 is another Wio series tile. It is equipped withMG126chip, which supportsBluetooth communication. The module has been equipped withATMega SAMD21 ARM Cortex M0+controller, so the board is compatible withArduino Zero. Power is supplied via theUSB port type Cwith5 VorwithLi-Pol 3.7 Vbatteryviathebuilt-in JST connector. PI PI PIs on the board work with3.3 Vlogical voltage of which 6 pins are analog and 14 are digital.
Wio Lite MG261 - ATSAMD21.
Wio Lite MG126 - ATSAMD21.
The Wio Lite W600 is equipped with 14 digital I/O pins and 6 analogue inputs operating at 3.3 V with a maximum current of up to 40 mA per pin. The module is powered via USB-C socket with 5 V or via Li-Pol battery via JST connector.
Distribution of the outputs on the Wio Lite board MG126.
There are 6 LEDs on the board:
- SCK LED:SPIclock diode.
- TX LED: LED for UART bus data transmission.
- RX LED: UART bus data off.
- User LED: LED without assigned function, can be controlled by software.
- Charging indicator - LED indicating charging of the connected Li-Pol battery.
- Reset LED - LED lights up when the reset button on the board is pressed.
Programming of the Wio Lite module MG126 - ATSAMD21 Bluetooth
The MG126 Wio Lite module is based on a systemAtmel SAMD21 Cortex-M0+ as well as Arduino MKRZeroso it should be fully compatible with it. The board is programmed using Arduino IDE environment. The manufacturer prepared ready-made MG126 library with sample codes.
|
The product is compatible with Arduino. The manufacturer has prepareduser's guidethat describes programming of the board using Arduino IDE. |
The set includes
- Wio Lite module M126
- Goldpin connectors
Wio Lite specification MG126 - ATSAMD21 Bluetooth
- Power supply:
- USB C - 5 V
- Li-Pol battery - 3.7 V
- Pin capacity 3.3 V: 40 mA
- SAMD21 Atmel System
-
- The core: Cortex-M0+
- Maximum clock frequency: 48 MHz
- SRAM: 32 kB
- Flash memory: 256 kB
- I/O ports: 20
- Number of analog inputs: 6 (A/C converter channels with resolution up to 12 bits)
- Serial interfaces: UART, ICSP, I2C
- MG126 - Bluetooth
- Frequency: 2.4 GHz
- the speed of data transmission: 1 Mb/s
- Communication with microcontroller: SPI up to 4 Mb/s
- Range: up to 10 m
- USB-C socket
- JST raster socket 2,00 mm
- Plate dimensions: 50 x 22 mm
Useful links |
