Description: Devil Design PLA Filament 1,75 mm 1 kg - Dark Orange
Filament for 3D printers - PLA filament in Dark Orange colour with weight 1 kg and diameter 1,75 mm. All is safely vacuum packed with moisture absorber. Filaments produced by Devil Design are suitable for all 3D printers not protected against the use of third-party cartridges and for open source devices.
In our offer of filaments you will also find other materials and colors.
Filament Devil Design PLA 1,75 mm 1 kg - Dark Orange.
Properties of PLA filament
PLA filament is a thermoplastic polyester produced mainly from renewable resources, so it's biodegradable. PLA is characterised by very low shrinkage and increased UV resistance. Due to its minimal water absorption, it is used for food packaging, surgical threads, and even implants. In addition, it is not flammable, which significantly increases safety at work. PLA is fully waterproof and has a high resistance to warping. PLA felt because of its properties and ease of use is intended for 3D printer beginners, among others.
Suggested parameters for printing with PLA felt
| Printing temperature | From 200°C to 235°C |
| Table temperature | From 50°C to 60°C |
| Print cooling | Recommended |
| Due to differences in construction of printers, the above data should be treated as guidelines, and the appropriate values should be determined experimentally. |
Technical specification and physical properties of Devil Design felt
| Parameter | Range |
|---|---|
| Filament diameter | 1,75 mm |
| Dimensional tolerance of the felt | +/- 0.05 mm |
| Colour | Dark Orange |
| Printing temperature | From 200°C to 235°C |
| Table temperature | From 50°C to 60°C |
| Spool - material | PLA |
| Melting point of material | Approximately 50°C |
| Material shrinkage | Very low |
| Packaging | Carton |
| Moisture absorber | Yes |
| Density | 1.24 g/cm3 |
| Roundness | +/- 0,02 mm |
| Net weight | 1 kg |
Useful links |
