- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: 4-digit 7-segment display module 0.56 '' Backpack - Yellow I2C - STEMMA QT / Qwiic - Adafruit 879
A 7-segment display with four digits and dots and a Backpack plate by Adafruit. The total diagonal of the display with yellow backlight is 0.56 " , the backlight can be dimmed at a resolution of 1/16 step. Thanks to the built-in matrix controller of the MAX7219 type, there is no need to connect a large number of wires, the whole is controlled via the I2C interface. Two modules can be found on the module. quick connect connectors - Qwiic / STEMMA QT The bottom part of the board contains jumpers for selecting the I2C address, so you can connect up to eight 7-segment display modules .
The product is compatible with Arduino and Raspberry Pi
The manufacturer has prepared a user guide that presents connection diagrams and code examples in Arduino and CircuitPython.
Backpack board with HT16K33 LED driver for segment display.Pins of the 7-segment display module
The module communicates with the microcontroller via the I2C interface, on the board you can also find 2 Qwiic / STEMMA QT connectors for quick connection with modules equipped with the same connector. The supply voltage is 3 V or 5 V.
- VCC - supply voltage 3 V / 5 V
- GND - the ground of the system
- SDA - data line of the I2C interface
- SCL - clock line of the I2C interface
Backpack segment display module specification
- Chip: HT16K33
- Number of digits: 4
- Number of segments: 7
- Backlight color: yellow
- Interface: I2C
- Backlight brightness adjustment: 1/16 steps
- Two Qwiic / STEMMA QT connectors
- I2C address: from 0x70 to 0x77 - selected with jumpers
- Requires self-soldering
- Backpack tile dimensions: 50 x 26.7 x 6 mm
- Backpack plate weight: 5.6 g
- Display dimensions: 19 x 50 x 14 mm
- Display weight: 8.4 g
Kit contents
- Backpack tile
- Display 7-segment, 4-digit, 0.56 "
- Golpin strip 6-pin 2.54 mm pitch
Kit contents.
