- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: OpenMV Cam PureThermal - development kit with 5 Mpx camera and FLIR Lepton socket - SparkFun DEV-18482
PureThermal OpenMV was developed by GetLab and OpenMV, whose idea was to create a module equipped with a professional thermal imaging camera. The board has an embedded STM32H743XI microcontroller, a 5 Mpx OV5640 camera module, a slot to support any FLIR Lepton, and a VL53L0X laser rangefinder to help draw the thermal image on the color image using the appropriate offset/scaling. The module is based on OpenMV Cam H7 Plus from OpenMV. It is programmed using the OpenMV IDE, supports TensorFlow, and can handle neural networks, object tracking or person detection.
OpenMV Cam PureThermal - development kit with 5 Mpx camera and FLIR Lepton socket - SparkFun DEV-18482.Technical specification of OpenMV Cam PureThermal
- STM32H743XI ARM Cortex-M7 SoC microcontroller running at 480 MHz
- 64 MB SDRAM running at 400 MB/s
- 32 MB QUADSPI Flash memory working at 50 MB/s
- RTC
- Camera sensor OV5640
- Sensor: 5 Mpx
- Resolution: 2592 x 1944 px
- Supports autofocus
- FLIR Lepton socket
- Supports FLIR Lepton 1 / 2 / 2.5 / 3 / 3.5
- Supports non-radiometric / radiometric Leptons seamlessly
- Laser Rangefinder VL53L0X
- Maximum measurement distance: up to 2 meters
- MicroSD card slot
- Supports microSD SD / SDHC / SDXC card
- Supports FAT12 / FAT16 / FAT32 / exFAT
- RGB LED indicator
- Buzzer with adjustable volume and audio notification frequency
- WINC1500 WiFi Soc (FCC certified)
- Can stream compressed MJPEG images at up to 12 Mbps using RTSP protocol
- Can be used to connect to the Internet for any purpose
- Display:
- 4.3'' 800x480 IPS TFT capacitive touch LCD
- 24-bit with 60 Hz refresh rate
- Backlight dimming supported
- Up to 5 simultaneous touch detection points for Rich GUI support
- Gesture detection, zoom in/out function
- HDMI display output
- Supported resolution up to 1280 x 720 px at 60 Hz
- 1920 x 1080 px resolution is supported in special cases
- 1920 x 1080 px at 30 Hz for dynamic images
- 1920 x 1080 px at 60 Hz - static images
- USB Type-C for power, charging, and connecting to a computer
- 32 MB QUADSPI files or microSD card are available via USB
- The board appears as a 12 Mbps virtual COM port
- SparkFun Qwiic connector for connecting external I2C devices
- Li-Pol battery connector for battery power
- Battery will be charged when USB type C is connected
- 10 GPIO pins with special function support:
- 1 DAC / ADC pin (3.3 V)
- 2 asynchronous serial ports RX / TX (up to 7.5 Mb/s)
- 1 CAN bus (up to 1 Mb/s)
- 1 SPI bus (up to 80 Mb/s)
- 1 I2C bus (up to 1 Mb/s)
- 2 servo channels
- PWM on each GPIO
- Interrupts (rising/falling) on each GPIO
- Standard ARM SWD-JTAG connector
