- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: MW-UDB RFID wall reader - 125kHz - black
The Netronix MD-UDB wall-mounted RFID reader allows for contactless reading of data from Unique transponders. These transponders have a unique 40-bit identification number permanently saved. Each transponder has a unique identification number. The MD-UDB reader uses the 1-wire bus to transmit data read from transponders, the data from the reader is sent in a format compatible with DS1990 chips. The device is also equipped with a touch button, after pressing which the 1-wire bus will be shorted to ground and the device will emit a sound. MD-UDB also has a LED indicator, which lights up red when the reader is connected to the power supply. Feeding the control input (yellow wire) with voltage from 3 V to 14 V causes the color to change to green. The reader works with the voltage from 7 V to 25 V. Black housing version.
MW-UDB RFID wall reader.
Reader pins.Leads of the Netronix MW-UDB RFID wall reader
The MW-UDB wall reader from Netronix uses a 1-wire interface to transmit IDs from transponders. The device is equipped with 4-wires:
- brown - power supply from 7 V to 25 V
- white - mass
- green - 1-wire (data output) / UART TX (bootloader)
- yellow - LED / UART RX control input (bootloader)
Specification of the RFID Netronix MW-UDB reader
- Supply voltage: 7 V to 25 V
- Current consumption: 120 mA (average 25 mA)
- Built-in antenna operating frequency: 125 kHz
- Transponder reading speed: RF / 64 (1953 b / s)
- LED color switching voltage: 3V to 14V
- Reading range: up to 6 cm
- Antenna: built-in
- Interface: 1-wire (Dallas 1990)
- Distance between fixing pins: 42 mm
- Reader damage voltage: +/- 30V
- IP protection class: IP54
- Relative humidity: up to 95%
- Working temperature: -20 ° C to 50 ° C
- Housing color: black
- Dimensions: 83 x 44 x 14 mm
Set contains
- MW-UDB RFID wall reader - 125kHz - black
- Pins and mounting screws
Kit contents. Useful links |
