- EOL
|
Attention! The product has been discontinued. Check others products incategory. |
Description
The set includes a device for doing thermal images FLiR Lepton with the board that simplifies the connection. Module has a resolution of 80 x 60 px and register IR radiation in the range from 8 to 14 μm. Is supplied with the voltage from 3 V to 5 V. Image transmission requires a connection via the SPI bus. Cameras can be configured through the I2C interface but this connection is not required.
|
The product is compatible with Arduino The manufacturer providesa sample program on GitHubwith a description of the connection for users ofArduino. |
What's in the kit?
The kit consists of two separate parts that need to be interconnected:
- camera module FLiR Lepton -is extremely sensitive to electrostatic discharge so, before you insert it into the tile, make sure taht on the palms are not left dangerous charges.
- the printed circuit boardwith soldered leads, goldpin type 2.54 mm.
Device for doing thermal images, which must be placed in, attached to a set, printed circuit board with leads.
Specification
- Supply voltage: from 3.0 V to 5.0 V
- The range of wavelengths: from 8 µm to 14 µm
- Angle measurement: 51,0° for HFOV mode and 63,5° for diagonal
- Resolution: 80 (h) x 60 (V) of active pixels
- Thermal sensitivity: less than 50 MK
- Interface for transmissing the image: SPI and MIPI
- Configuration interface: I2C
- The waiting time of the image: less than 0.5 sec
- Average power consumption: 150 MW
Leads
The system has 8 leads in the form of soldered strap goldpin with pitch of 2.54 mm, which allows you to connect to the breadboard or connect via the wires.
| Pin | Description |
|---|---|
| VIN | Supply voltage from 3.0 V to 5.0 V. |
| GND | The mass of the system. |
| CS | Chip Select - selects a device of the SPI bus. |
| MOSI | Master out - slave in - data line of SPI bus. |
| MISO | Master in -slave out - data line SPI bus. |
| CLK | Clock line of the SPI bus. |
| SDA | Data line of I2C bus, pulled by a 1kΩresistor to the supply voltage. |
| SCL | Clock line of the I2C bus, pulled by a 1kΩresistor to the supply voltage. |
Configuration change
After changing the settings of the camera, remove the device from the PCB and insert it again. Detaching and re-powering only, is not enough.
Useful links |
