- On sale!
Product description: Wall mounted RFID reader UW-D4G - 125 kHz
Thewall mounted RFIDreader, supports HID ISOPROX II, HITAG 1, HITAG 2, HITAG S, Q5, Unique (EM4102) standards. The device operates at frequency of 125 kHz. For communication it uses Netronix and MODBUS protocols. UW-D4G is equipped with RS485 interface. Reader has built-in antenna, buzzer, relay and two signaling LEDs.
Reader is equipped with RTC clock with battery backup and synchronization pin for readers working in close proximity. The device has a card memory with a built-in lock controller. Transmitted data are password protected.
The set includes
- Wall mounted RFID reader UW-D4G
- Screw connectors
- Screws and plugs
Wall-mounted RFID readerUW-D4G - 125 kHz.
The wall-mounted RFID reader UW-D4G has terminals, located at the rear of the housing.
Specification of the RFID reader UW-D4G
- Supply voltage: from 7 V to 16 V
- Maximum current consumption: 120 mA
- Frequency of operation: 125 kHz
- Unique transponders reading distance: up to 12 cm
- Communication interface: RS485
- Supported standards: HID ISOProx II, HITAG 1, HITAG 2, HITAG S, Q5, Unique (EM4102)
- Binary inputs / outputs configuration function
- Control of two-state outputs
- Reading out two-state inputs
- Built-in: antenna, LEDs, buzzer, relay
- Degree of protection: IP54
- Working temperature: from -20°C to 65°C
- Relative humidity: from 15% to 95%
- Dimensions: 82 x 82 x 22 mm
Pinout description
| Pin | Description |
|---|---|
| 1 | I0 1 |
| 2 | Pin for synchronization of two readers |
| 3 | RS485 pin A |
| 4 | RS285 pin B |
| 5 | Module power supply |
| 6 | GND |
| 7 | Output 1 relay contacts |
| 8 | Relay contact 2 output |
| T | Spring loaded tamper |
| A | I0 2 |
| B | I0 3 |
| C | I0 4 |
| D | I0 5 |
| E | I0 6 |
| F | Button used to return to the factory settings |
