- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: Wall mounted RFID reader MW-R4B - 13.56 MHz - black
Wall-mountedRFIDcardand transponder reader operating at frequencies of13.56 MHz. It is compatible with MIFARE Classis, MIFARE Plus, MIFARE Ultralight C, MIFARE DESFire, ICODE SLI, iClass (CSN) standards. The supported communication interface is RS485. The reader is equipped with two inputs and one output of any purpose. Device has built-in RGB LED, buzzer and touch button. Housing version in black colour. Mounting pins are included.
Pinout description
The reader haseightpins in a form of wires with stripped insulation, located on the back of the casing. Detailed description of each connector is given below.
RFID reader MW-R4B - 13,56 MHz - black.
| Leads description of MW-R4B reader | |||
|---|---|---|---|
| Cable color | Cable color Name | Function | |
| Red | VCC | Power supply | |
| Blue | GND | GND | |
| White | Anti-collision | Lead for connecting readers working close to each other | |
| Brown | PinOUT | Any purpose output | |
| Green | PinINTERFACE1 | Serial interface line: RS485_B | |
| Yellow | PinINTERFACE2 | Serial interface line:RS485_A | |
| Gray | PinIN0 | Any purpose input | |
| Pink | PinIN1 | Any purpose input | |
Set contents.Specification for MW-R4B RFID Reader
- Supply voltage: 8 V to 15 V
- Maximum supply current: 120 mA
- Average current consumption: 25 mA
- Rated RF Frequency: 13.56 MHz
- Supported standards: MIFARE Classis, MIFARE Plus, MIFARE Ultralight C, MIFARE DESFire, ICODE SLI, iClass (CSN only)
- Supported communication interfaces: RS485
- Operation with Netronix and MODBUS-RTU protocol
- Number of GPIO pins: 3
- Card and transponder reading distance: up to 8 cm
- Protection class: IP54
- Front button type: capacitive
- Built-in buzzer, antenna, RGB LED
- Housing colour: black
- Dimensions: 83 x 44 x 14 mm
Useful links |
