- EOL
|
Attention! The sale of the product has been completed. Check otherdevices in this category. |
Description
Banana Pi M2 is a minicomputer equipped with 1 GB of RAM, Allwinner A31S ARM Cortex A7 1GHz quad core processor and connectors known from Raspberry Pi, among others: 4 x USB, slot forSD card, HDM, audio jack. The board has also 40 GPIO pins and communication interfaces UART, I2C, SPI. Built-in buttons: Reset, Power, Uboot and infrared receiver are helpful while using the module.
|
The advantage of Banana Pi M2 is a quad-core processor and built-in WiFi module. This version does not have a SATA port, if you are looking for a minicomputer with this bus checkthe other versions of Banana Pi. |
Specification
- CPU: Allwinner A31S
- The core: ARM Cortex-A7 quad-core,
- Clock: 1 GHz
- Cache: L1 256 KB, MB L2
- RAM: 1 GB DDR3
- Graphics: PowerVR SGX54MP2
- Built-in WiFi module
- U.FL socket for connectingan external WiFi antenna
- Slot forSD memory card
- HDMI socket
- Jack 3.5 mm audio, video
- Built-in microphone
- Ethernet port
- 4 USB ports
- 40 pins GPIO
- Interface for connectinga dedicated camera
- Three built-in buttons: Power, Reset, Uboot
- Built-in infrared receiver
- Dimensions: 92 x 60 mm
- Weight: 48 g
Image and sound
Banana Pi has anHDMI connectionthrough which both video and audio can be transmitted. In addition, the board is equipped with a jack connector, to which you can connect headphones or output an analog video signal.
Operating system
Banana Pi is amicroSD memory card. The operating system can be uploaded using a computer with a reader. The board supports, among others, systems: Android, Android 4.4, Debian, Ubuntu and Raspbian. Installation instructions can be found on the web...
Communication
Banana Pi has basic communication interfaces, which can be found in PC-class office computers. In addition to the previously mentioned audio and video interfaces, the user has at his disposal:
- four USB connectors,under which you can connect e.g. a mouse, a keyboard, a WiFi card or a flash drive. If it turns out that there are too few connections, you can increase their number usingan external USB HUB.
- Ethernet socket, i.e. the possibility of direct connection to the LAN.
- WiFi module- Banana Pi M1+ has a built-in WiFi module with a connector foran external antenna.
- 40 x GPIO- general purpose outputs/inputs which can be used to operate LEDs, buttons, motor controllers. Among them there are pins supporting I2C, SPI and UART interfaces.
- Camera output- connector for dedicatedBanana Pi camera.
Power supply .
The system uses the microUSB connector as the power source. In practice, this means that amobile phonecharger with acapacityof at least 2 A can be used to run the Banana Pi, such as the Extreme power supply.
| To avoid voltage drops, it is recommended to use a 4 x 1.7 mm connector to power the module. When powered via microUSB, the 2 USB ports located at the Ethernet connector will not work. For this purpose, you can use any 2 A power supply unit with a 4 x 1.7 mm connector, e.g.Blow. |
Accessories
Our offer also includesHDMI cables,memorycards,microUSBpower suppliesandcompatible enclosures.
In the picture you can see a Banana Pi M2 mini computer in a housing.
