- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: Grove - XBee Carrier - XBee module holder
The stand is mainly designed forBee seriesmodules based on ATMega 328 chip. It isalsocompatible with RFBee, WiFi Bee, Xbee and Bluetooth Bee modules. There aretwo Grove connectorson the board. Powered by a lithium battery orUSB connector. The module is also equipped with aLi-Ionbatterycharger,a solar panel or a USB cable can be usedto chargethe battery. The FT232RL enables programming of Bee modules.
Stand for XBee modules, compatible Grove cable is also included.
Bee modules which are not equipped with the ATMega328 microcontroller can be configured using the FT232RLUSB -UART chip. The built-in FT232RL can be used with any 3.3 V USB - UART interface when no Bee module is connected. It is useful when programming 3.3 V circuits via serial port.
Stand for Bee series modules.
The main features of the XBee base
- Compatible with Bee modules
- Two Grove connectors - I2C and D6, D5
- Built-in charger driver - CN3063
- Built-in voltage regulator 3.3 V - RT9167A_33PB
- Built-in USB - UART - FT232RL
- Status LEDs - PWR, charging status and UART transmission
- Power switch
- Reset button
- JST 2 mm connector for power and battery charging
Use of the XBee stand
- Wireless sensor network using WiFiBee module
- Programming board for Bee series modules using FT232RL
- Li-Ion battery charger using a built-in controller
- USB - UART converter powered by 3.3 V
Specification of the XBee cradle
- Supply voltage: 3 V to 3.6 V (typical 3.3 V)
- Charger controller: CN3063
- Charging voltage: 4.4 V to 6 V
- Charging current: max. 500 mA
- USB converter - IART: FT232RL
- Connections: miniUSB, 2x Gove, 2x JST raster 2 mm
- Dimensions: 130 x 90 mm
- Weight: 20 g
Useful links |
