- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
The driver allows to control two DC motors powered by voltage from 6 Volts to 34 V with continuous current consumption of up to 45 A (temporary up to 60 A). System RoboClaw communicates through computer's USB port, the digital signal UART, TTL, radio RC interface,or analog signal. This version has soldered screw connectors.
This version has the screw connections to connect the control signals.
Key features
- Supply voltage from 6 V to 34 V
- Continuous current per channel: up to 45 A
- Instantaneous current per channel: up to 60 A
- Communication:
- USB - emulated COM port -the microUSB cable, please, purchase separately.
- UART serial interface - TTL
- The signal from the RC radio receiver
- Analog voltage ranging from 0 V to 2 V (tolerates the value of 5 V)
- Feedback, for example, for a PID loop:
- The possibility to connect the square encoders with a resolution of up to 19.6 million pulses per second
- The position control using analog encoders (potentiometers)
- The possibility to work without feedback, so called open control loop
- Mounted screw terminal facilitating the connection
- The possibility of configuration via built-in buttons
- The possibility of attaching the BEC regulator using the jumper
- Monitor of battery charge, cut-off of the voltage at too low voltage
- Board sizes: 74 x 52 mm
- Weight: 63 g
|
The manufacturer provides: |
Comparison of RoboClaw drivers
| 2x7A | 2x15A | 2x30A | 2x45A | 2x60A | |
|---|---|---|---|---|---|
| Number of channels: | 2 | ||||
| Voltage: | from 6 V to 34 V | ||||
| Continuous current: | 7.5 A | 15 A | 30 A | 45 A | 60 A |
| Instantaneous current: | 15 A | 30 A | 60 A | 60 A | 120 A |
| Current BEC 5 V: | 150 mA | 3 A | 3 A | 3 A | 3 A |
| Width: | 42 mm | 52 mm | 52 mm | 52 mm | 86 mm |
| Length: | 48 mm | 74 mm | 74 mm | 74 mm | 100 mm |
| Weight: | 18 g | 60 g | 60 g | 63 g | 295 g |
Useful links |
