- EOL
|
Attention! The product has been discontinued. Check other products incategory. |
Description of Odroid C2 - Amlogic S905 Quad-Core 1.5GHz + 2GB RAM
Minicomputer Odroid, version C2 with an efficient processor Amlogicquad-core 64-bitARM-8Cortex-A53 1.5 GHz. Circuit Board has2 GB of RAMDDR3, built-in Ethernet port, an HDMI port 2.0 4K/60 Hz and four USB ports, 40 GPIO, connectors for memory card microSD, and the IR receiver. Works with theUbuntu 16.04, orAndroid 5.1 Lollipop.
What it takes to run minicomputer Odroid?
- The microSD card or eMMC- drive, where you will install operating system
- AC adapter:
- Housing- protects minicomputer from the influence of external conditions
- HDMI cable- to connect the device to the monitor
- Mouse and keyboard - for control and inputting data into the device
In our store are also availableoptional accessories- - type of wi-fi card,touchscreen display, orthe module USB 3.0 - SATA
Operating system
Odroid C2 works with Ubuntu 16.04 and Android 5.1, which is based on kernel 3.14 LTS. The drive of device may be a microSD card or a Flash memory eMMC 5.0 HS400.
|
Systems Ubuntu and Android can be downloaded fromthe manufacturer's website. The installation is very simple -check out our manual! |
Package includes mounted radiator.
Communication
Odroid has the basic communication interfaces, which can be found in office computers of PC class. In addition to the previously listed connectors of audio and video, the user has at his or her disposal:
- four USB connectors, to which can be connected, for example, a mouse, a keyboard, a wi-fi card or USB flash drive. If you find that the slots are too short, you can increase their number usingan external USB HUB.
- Ethernet socket, that is the ability to directly connect to the network.
- GPIO X 40 pin - outputs/inputs with general purpose that can be used to control the LEDs, buttons, drivers, engines. Among them are the pins supporting interfaces: I2C, SPI and UART.
- a slot for microSDslot for memory cards microSD, which can be installed with the operating system.
Power
As a power source, the system uses a DC connector Jack. Manufacturer recommends that the voltage indicated on the connector had a value of 5.0 and an output current of the used power supply shall not be less than 2.0 A. In our assortment you will finda specialpower supply.
Odroid C2 has aHDMI port, through which you can send image and sound, both in 4k.
Cases
In our assortment you will findspecial housings that protects minicomputer Odroid from the external conditions. Special power supplies are also available.
Specifications and comparison
| Basic information | ||||
 |
 |
 |
 |
|
| Model | Odroid C0 | Odroid C1+ | Odroid C2 | Odroid XU4 |
| Specification |
||||
| Processor | Amlogic S805 | Amlogic S805 | Amlogic S905 | Samsung Exynos5422 |
| The core |
Quad-Core 32-bit ARM Cortex A5 |
Quad-Core 32-bit ARM Cortex A5 |
Quad-Core 64-bit ARM Cortex-A53 |
Octa-Core ARM Cortex-A15 ARM Cortex™-A7 |
| Graphics |
ARM Mali 450MP OpenGL ES 2.0/1.1 |
ARM Mali 450MP OpenGL ES 2.0/1.1 |
ARM Mali 450MP OpenGL ES 2.0/1.1 |
3D Mali-T628 MP6 OpenGL ES 3.0/2.0/1.1 |
| Systems |
Ubuntu 14.04 Android 4.4 Kernel 3.10 LTS |
Ubuntu 14.04 Android 4.4 Kernel 3.10 LTS |
Ubuntu 16.04 Android 5.1 Kernel 3.14 LTS |
Ubuntu 15.04 Android 4.4.2 Kernel 3.10 LTS |
| Clock frequency | 1.5 GHz | 1.5 GHz | 1.5 GHz | 2 GHz / 1.4 GHz |
| Architecture | ARMv7 | ARMv7 | ARMv8 | ARMv7 |
| RAM |
1 GB DDR3 SDRAM |
1 GB DDR3 SDRAM 792MHz |
2 GB DDR3 SDRAM 792Mhz |
2 GB LPDDR3 RAM 750Mhz |
| Memory |
microSD memory card UHS1 eMMC4.5 HS200 |
microSD memory card UHS1 up to 16 GB eMMC4.5 |
microSD memory card UHS1 with capacity up to 128 GB eMMC5.0 |
microSD memory card The UHS1 up to 64 GB eMMC5.0 |
| Connector GPIO |
Connector 40-pin + 7-pin I2S (must be soldered) |
Connector 40-pin + 7-pin I2S |
Connector 40-pin + 7-pin I2S |
Connector 30-pin + 12 pin I2S raster 2mm |
| Power |
5 V / 2 A DC Jack |
5 V / 2 A DC Jack |
5 V / 2 A DC Jack |
5 V / 4 A DC 2,5x2,1mm |
| Tile sizes | 58x56x11mm | 85x56x18mm | 85x56x18mm | 82x58x22mm |
| Interfaces | ||||
| USB-Host |
2 x USB 2.0 (optional soldering) |
4x USB 2.0 connector type a |
4x USB 2.0 connector type a |
2x USB 3.0 1x USB 2.0 connector type a |
| USB OTG | - |
1x microUSB |
1x microUSB | - |
| Network interface | - |
Ethernet 10/100/1000 Mbit/s |
Ethernet 10/100/1000 Mbit/s |
Ethernet 10/100/1000 Mbit/s |
| The RTC system | Built-in | Built-in | - | - |
| Video | HDMI | HDMI | HDMI 2.0 4K/60 Hz | HDMI 1.4 a |
| Audio |
HDMI / I2S |
HDMi |
HDMI / I2S |
HDMI |
|
ADC Transducer |
2 channels 10-bit |
2 channels 10-bit |
2 channels 10-bit |
2 channels 10-bit |
| Communication |
UART, SPI, I2C, GPIO, ADC |
UART, SPI, I2C, GPIO, ADC |
UART, SPI, I2C, GPIO, ADC |
UART, SPI, I2C, GPIO, ADC |
Useful links |
