- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: Grove - Recorder v3.0 - sound recorder
Sound Recorder module based onISD9160FI chipequipped with 2 MB offlash memory, so it is possible to record a recordingof 83 seconds.The recorder can be used with a control module such as Arduino and as a standalone device. In addition, the recorder has a built-in button that allows you to play the recorded sound directly from the supplied speaker without the need for additional cables to the created project.It works with voltage of 3.3 V.
In the set with the recorder there is a dedicated speaker.
Control of the sound recorder - Grove - Recorder v3.0
The module can be used both with a control module such as Arduino orRaspberryusingdigital signal to control or as a standalone device including recording and playback with built-in button. Detailed information on this use of the device can be found in theuserguidepreparedby the manufacturer.
|
Arduino compatible product The manufacturer provides auser guide witha sample program. |
Sound Recorder - Grove - Recorder v3.0
The recorder is equipped with Grove connector allowing for direct connection to GroveBase Shield v2 orGrove-Pi+,soconnecting it to Arduino or Raspberry does not require additional wires or soldering.
| Pin | Description |
|---|---|
| PLAY | Pin controls the sound playback. |
| REC | Pin controlling the sound recording. |
| VCC | Supply voltage 3.3 V. |
| GND | The weight of the system. |
The set includes
- Recorder module v3.0
- Analogue loudspeaker
- Grove cable
Grove specification - Recorder v3.0 - sound recorder
- Power supply voltage: 3,3 V
- Power consumption:
- Idle: 23 to 25 mA
- Recording: 25 to 30 mA
- Playback: 70 to 150 mA
- System: ISD9160FI
- Flash memory: 2 MB
- Built-in button: Play / Record
- Volume control potentiometer
- Record switch: set to ON for software audio recording
- Operating temperature: 0 °C to 85 °C
- Dimensions: 40 x 20 x 10 mm
- Weight: 31,5 g
Useful links |
