- EOL
Attention! The product has been discontinued. Check others products incategory. |
Description
MinicomputerNanoPiin versionDuo withprocessor Allwinner H2+ quad-core ARM Cortex-A7 with a clock frequency of 1.2 GHz. The board has512 MB of DDR3 RAM, integrated wi-fi,2 USB hosts on 2.54 mm pinx,16 GPIOs, popular interfaces and microSD card socket. Works with systemsUbuntuCoreandLinux.
The advantage of board is its small size, the dimensions of the board are: 50 x 25.4 mm.
How to run the minicomputer NanoPi?
- MicroSD memory card - with the operating system installed on it
- AC adapter with a microUSB connector- 5 V maximum load current 2 A
The device has a wi-fi module and other popular interfaces.
Operating system
NanoPi works with the systems chosen by the manufacturer: UbuntuCore and Linux Lastest Mainline Kernel 4.11. The device's drive may be a microSD card, which can be purchased in our store.
Operating systems can be downloaded fromthe manufacturer's website. The manufacturer also providesguide on the installation of the system. |
Communication
Minicomputer has basic communication interfaces that can be found in office PCs. In addition to the previously listed connectors of audio and video, the user has at their disposal:
- 2x USB hosts on pins 2.54 mm, to which can be connected, for example, a mouse, a keyboard, a wi-fi card or USB flash drive. If you find that the slots are too short, you can increase their number using an external USB HUB. The interfaces displayed on pins can be connected using wires.
- wi-fi module - wireless 802.11 b/g/n
- Ethernet connector 10 / 100 MHz for deriving from the pins 2.54 mm
- 16 x GPIO pin - that can be used to control the LEDs, buttons, drivers of engines. Among them are the pins supporting interfaces: I2C, SPI and UART. Pins are already mounted.
- microSD slot - slot for microSD memory cards, on which can be installed the operating system.
Distributions of GPIOs, the module has already soldered goldpincontacts.
Power
As a power source, the system uses the microUSB connector. The manufacturer recommends that the voltage indicated on the plug had a value of 5.0 V and the current of the used adapter shall not be less than 2.0 A. In our assortment, you will find power supplies that meet these parameters, for example: power supply Extreme 2.1 A.
Starter set
The manufacturer has prepareda set of sensors and modulesin a convenient box that simplifies the process of getting started with the minicomputer.
The contents of the setMatrix Starter Kit- sold separately.
Specification |
|
Model | NanoPi Duo |
Specification |
|
Processor | Allwinner H2+ |
Core |
Quad-Core ARM Cortex A7 |
System |
Linux Kernel 4.11.2 UbuntuCore |
Clock frequency | 1.2 GHz |
RAM |
512 MB |
Memory |
microSD memory card |
Connector GPIO |
16 pin connector soldered into the board |
Food |
5 V / 2 A - microUSB |
Tile sizes | 50 x 25.4 mm |
Interfaces | |
USB-Host |
2 x USB Hosts on pins 2.54 mm |
Network interface | Ethernet 10/100 Mbit/s on pins 2.54 mm |
Video | -CVBS on pins GPIO |
Audio |
audio output and microphone out on the GPIO connector |
Link |
Wi-fi, UART, SPI, I2C, GPIO, PWM |
Debugger |
Serial port 4pin / 2.54 mm |
Others |
Reset button, connector u.FL for additional antenna |
Useful links |