- EOL
|
Attention! The product has been discontinued. Check others products incategory. |
Description
Miniature computerNanoPiin versionNeo 2 with processorAllwinner H5 quad-coreARM Cortex-A53 with a clock frequency of 1 GHz. Tile has512 MBof memoryRAM DDR3, built-in portEthernet 10/100/1000 Mbit / sandUSB slot + 2x USB Host on pins 2.54 mm,36 GPIO, connector for card microSD. Works with systems from manufacturer of u-boot and UbuntuCore.
The advantage of tile is its small size, the dimensions of the tile - 40 x 40 mm.
What it takes to run minicomputer NanoPi?
- MicroSD memory card - carrier, on which the operating system will be installed
- The AC adapter with a microUSB connector- 5 V with current capacity of 2 A
The device has a USB plug connector and an Ethernet port and many others.
Operating system
NanoPi works with the systems selected by manufacturer: u-boot and UbuntuCore. The drive of device may be a microSD card which can be purchased in our store.
|
Operating systems can be downloaded fromthe manufacturer's website. The manufacturer also providesguide on the installation of the system. |
Communication
Minicomputer has basic communication interfaces that can be found in office computers of PC class. In addition to the previously listed connectors of audio and video, the user has at his or her disposal:
- 1x USB A connector + 2x USB Host on pins 2.54 mm, to which can be connected, for example, a mouse, a keyboard, a wi-fi card or USB flash drive. If you find that the slots are too short, you can increase their number usingan external USB HUB. The interfaces displayed on pins can be connected using wires.
- Ethernet slot, that is the ability to directly connect to the network.
- GPIO x 36 pin - outputs/inputs with general purpose that can be used to control the LEDs, buttons, drivers of engines. Among them are the pins supporting interfaces: I2C, SPI and UART. Pins are already mounted.
- a slot for microSD -slot formicroSD memory cards, on which can be installed the operating system.
The distribution of the GPIO pins.
Power
As a power source, the system uses the microUSB connector. The manufacturer recommends that the voltage indicated on the plug had a value of 5.0 V and the current of the used adapter shall not be less than 2.0 A. In our assortment, you will findpower supplies that meet these parameters, for example:power supply Extreme 2.1 A.
In our offer, you will find alsospecial radiator.
Starter set
The manufacturer has prepareda set of sensors and modulesin a convenient chest that simplifies getting started with minicomputer.
The contents of the setMatrix Starter Kit- sold separately.
Specification |
|
| Model | NanoPi Neo 2 |
| Specification |
|
| Processor | Allwinner H5 |
| The core |
Quad-Core ARM Cortex A53 |
| Systems |
u-boot UbuntuCore |
| Clock frequency | 1 GHz |
| RAM |
512 MB |
| Memory |
microSD memory card |
| Graphic |
MAIL450 GPU |
| GPIO slot |
36-pin connector |
| Power |
5 V / 2 A - microUSB |
| Tile sizes | 40 x 40 mm |
| Interfaces | |
| USB-Host |
1 x USB A slot 2 x USB Host on pins 2.54 mm |
| Network interface | 10/100/1000 Mbit / S Ethernet |
| Video | - |
| Audio |
audio output and microphone out on the GPIO connector |
| Communication |
UART, SPI, I2C, GPIO, PWM |
| The debugger |
Serial port 4pin / 2.54 mm |
| Additional |
Built-in led |
Useful links |
