- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: RFID wall-mounted reader MW-D7B - 125 kHz - black.
Wall mountedRFIDcard and transponder readercompatible withUnique, HITAG, Q5 and HID standards. The device uses125 kHzfrequency for operation. It supports four communication interfaces: RS232, RS485, 1-Wire and WIEGAND. MW-D7 has a capacitive touch button, built-in buzzer, antenna and LED. The reader has two inputs and one output for any purpose. Product in black colour version.
MW-D7B - 125kHz RFID wall-mounted reader - black.
Output description
The reader haseight leadsin the form ofwireswith removed insulation, placed on the back of the casing. Below is a description of individual connections.
| Description of reader's outputs MW-D7 | |||
|---|---|---|---|
| The colour of the cable | Name | Function | |
| Red | VCC | Power supply | |
| Blue | GND | Mass | |
| White | Anticolliosis | Bringing readers working closely together | |
| Brown | PinOUT | Any destination | |
| Green | PinTERFACE1 | Serial interface line: RS232_TX, RS485_B, WIEGAND0, 1WIRE | |
| Yellow | PinTERFACE2 | Serial interface line:RS232_RX, RS485_A, WIEGAND1 | |
| Grey | PinIN0 | Entry for any purpose | |
| Pink | PinIN1 | Entry for any purpose | |
Functions available for different types of cards and transponders.
| Support for functionalities depending on transponder type | |||
|---|---|---|---|
| Transponder type | Reading the ID number | Full memory block writing and reading | Writing and reading using encryption |
| Unique | Yes | No | No |
| Q5 | Yes | Yes | No |
| HID | Yes | No | No |
| HITAG | Yes | Yes | Yes |
RFID reader specification MW-D7
- Supply voltage: 7 V to 15 V
- Rated RF frequency: 125 kHz
- Supported standards: Unique, HITAG, Q5, HID
- Supported communication interfaces: RS232, RS485, 1-Wire, WIEGAND
- Number of GPIO pins: 3
- Card and transponder reading distance: up to 8 cm
- Leakage class: IP54
- Front button type: capacitive
- Built-in buzzer, antenna, RGB LED
- Colour: black
- Dimensions: 83 x 44 x 14 mm
Set contents
- Reader MW-D7
- Mounting accessories: screws and studs
Useful links |
