- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description: Motor HP 6V 10000RPM with CPR 48 encoder for 25D gearboxes - Polol 4800
HP motor without gear, 10000 rpm, torque 0.35 kg*cm (0.03 Nm). Can be used as a replacement for a 25D high power (HP) gearbox kit. The motor encoder is covered by a plastic housing.
Motor with encoder - 6 V 10000 RPM.
Parameters for 6 V supply
- Turns: 10000 rpm
- Average power consumption: 275 mA
- Peak current: 6,5 A
- Torque: 0.35 kg*cm (0.03 Nm)
Encoders
Hall effect sensors detect pulses on a rotating magnetic disk at the back of the engine. Square encoders enable measurements with a resolution of 48 pulses per motor shaft revolution.
Close view of the encoder
Exits
- Red- motor power supply
- Black -engine power
- Green- encoder mass potential
- Blue- Encoder power supply (2.5 V - 20 V)
- Yellow -encoder A output
- White- encoder B output
The figure shows the signal from both encoder channels for a 25D low power motor (at 6 V)
Engine specification
- Supply voltage: 3 V to 9 V
- Dimensions: 46L x 25D mm
- Weight: 60 g
- Encoder resolution: 48 pulses per revolution
- Dedicated as a replacement for the 25D high power (HP) gearbox kit
Useful links |
