- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
Module with 32-bit microcontroller with ARM Cortex M4, 216 MHz, 1 MB Flash, 320 kB SRAM. In addition, the board has a 64 MB SRAM. Based on the system STM32F429IGT6. It allows to get acquainted with the system STM32F.
Specification
- Processor STM32F746IGT6:
- Frequency: 216 MHz
- Power supply voltage: 1.7 V to 3.6 V
- Flash memory: 1024 KB
- SRAM: 320kb
- Communication interfaces:
- 6 x SPI
- 4 x USART
- 4 x UART
- 3 x I2S
- 4 x I2C
- 2 x SAI
- 1 x FMC
- 1 x sdio format
- 2 x CAN
- 1 x QUAD-SPI
- 1 x DCMI
- 1 x SDMMC
- 14 x TIM
- 1 x LPTIM
- 1 x SPDIFRX
- 1 x HDMI-CEC
- 1 x LCD display TFT
- 1 x USB HS 2.0 OTG (supports external PHY via the ULPI HS)
- 1 x Ethernet 10 / 100
- 3 x inverter A/C: 12-bit
- 2 x Converter for C/A: 12-bit
- Debugging / programming: supports interface, JTAG / SWD, IAP support
- In addition, on the board there is 64 Mbits SRAM memory
- Reset Button
- MicroUSB connector (cable included USB - microUSB)
- Raster: 2 mm
- Dimensions: 83 x 57,50 mm
|
Detailed materials can be found inthe user guide. |
What is on the board?
- Processor STM32F746IGT6
- IS42S16400J: SDRAM, 1 MB x 16 b x 4 banks (64 Mb)
- MIC2075: built-in power management USB
- AMS1117-3.3: voltage regulator 3.3 V
- Quartz resonator 8 MHz
- Quartz resonator 32.768 kHz for internal RTC with calibration
- RESET button
- LED VBUS
- LED indicating the power
- Power switch: USB or 5VIN contact
- Selection of loading mode: for configuring the BOOT0 contact
- Interface JTAG / SWD for debugging and programming
- MicroUSB
- Put out pins CPU
- The power jumper
- VBAT: closed - power system, open - external power supply, e.g. battery
- VREF: closed - connect VREF+ to VCC, open - connect VREF+ to the other pins via optional cable
- closed: using USB HOST/OTG
- open: disconnecting from I/O ports
Useful links |
