Description
Station WEP 898BD has two LED displays, which can read the temperature for hot air and tip-based soldering iron. The temperature of the tip and the air is carried out using the buttons, adjustment of the fan with a regulator.
The device has a sensor in the base that, when you put the iron down, the station cools down the heating element in a time from 3 to 8 minutes, then the device enters a low energy consumption mode (the so-called standby mode). This mode allows to save energy, prolong the service life of the heater and increases safety. Station remembers the set temperature.
Specification
- Supply voltage: 230 V / 50 Hz (network)
- Power: 700 W
- The station is controlled by the microcontroller which ensures a high stability
- The device has a standby mode
- Remembers the set temperature
- Equipped with ergonomic housing
Hotair Soldering Iron
- Adjustable temperature hot air from 100 °C to 480 °C
- Temperature stability +/-1 °C
- LED display
- Temperature setting buttons,
- Infinitely adjustable air supply with regulator
- Air flow up to 120 l/min
- The head size of the hot air 22 mm
- The air flow is provided through a fan located in the handle
Soldering Iron Tip-based
- Soldering iron 907F
- Regulation of the soldering tip temperature from 200 °C to 480 °C
- Power: 75 W
- Temperature stability +/- 1 °C
Includes:
- Soldering station WEP 898BD+
- Stand for the hotair iron
- Set of nozzles:
- round with a diameter of 7 mm
- round with a diameter of 9 mm
- square 12x12 mm
- Stand for the tip-based iron along with a cleaning sponge
- Soldering iron 907F with T-B tip
- A gripper for lifting circuits
|
First run
Note Heating elements (heaters) and the tips are not subject to warranty, and you must purchase new ones. |
