- EOL
|
Attention! The product has been discontinued. Check others products incategory. |
Description
Miniature computerNanoPiin versionNeo v1.3 with processor -Allwinner H3 quad-coreARM Cortex-A7 with a clock frequency of 1.2 GHz. Circuit Board has256MBofRAMmemoryDDR3, built-in portEthernetandUSB slot + 2x USB Host on pins 2.54 mm,36 GPIO, connector for memory card microSD. Works with manufacturer's systems u-boot and UbuntuCore.
The advantage of tile is its small size, the dimensions of the tiles 40 x 40 mm.
What it takes to run minicomputer NanoPi?
- MicroSD memory card - media on which the operating system will be installed
- The AC adapter with a micro usb connector- 5 V with maximum load current 2 A
The device has a USB slot and an Ethernet port and many others.
Operating system
NanoPi works with the systems selected by manufacturer: u-boot and UbuntuCore. The drive of the device can be amicroSD card, which can be purchased in our store.
|
Operating systems can be downloaded fromthe manufacturer's website. The manufacturer also providesguide around the installation of the system. |
Communication
Minicomputer has basic communication interfaces that can be found in office computers of PC class. In addition to the previously listed connectors audio and video, the user has at his or her disposal:
- 1x USB A connector + 2x USB Host on pins 2.54 mm, to which can be connected, for example, a mouse, a keyboard, a wi-fi card or USB flash drive. If you find that the slots are too short, you can increase their number usingan external USB HUB. The interfaces displayed on pins can be connected using wires.
- Ethernet slot, that is the ability to directly connect to the network.
- GPIO x 36 pinoutputs/inputs with general purpose that can be used to control the LEDs, buttons, drivers of engines. Among them are the pins supporting interfaces: I2C, SPI and UART. Pins already soldered.
- a slot for microSDslot for memory card microSD on which the operating system can be installed.
The distribution of the GPIO outputs - the device has soldered goldpin pins.
Power
As a power source, the system uses the microUSB connector. The manufacturer recommends that the voltage indicated on the connector had a value of 5.0 V and output current of the used adapter shall not be less than 2.0 A. In our assortment you will findpower supplies that meet these parameters, for example:power supply Extreme 2.1 A.
In our offer you will find alsospecial radiator.
Starter set
The manufacturer has prepareda set of sensors and modulesin a convenient chest that simplifies getting started with minicomputer.
The contents of the setMatrix Starter Kit.
Specification |
|
| Model | NanoPi Neo |
| Specification |
|
| Processor | Allwinner H3 |
| The core |
Quad-Core ARM Cortex A7 |
| Systems |
u-boot UbuntuCore |
| Clock frequency | 1.2 GHz |
| RAM |
256 MB |
| Memory |
microSD memory card |
| GPIO socket |
36-pin connector |
| Power |
5 V / 2 A - microUSB |
| Tile sizes | 40 x 40 mm |
| Interfaces | |
| USB-Host |
1 x USB A socket 2 x USB Host on pins 2.54 mm |
| Network interface | Ethernet 10/100 Mbps |
| Video | - |
| Audio |
audio output and microphone out on the GPIO connector |
| Communication |
UART, SPI, I2C, GPIO, PWM |
| The debugger |
Serial port 4pin / 2.54 mm |
| Additional |
Built-in led |
Useful links |
