- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Product description: Wall mount RFID reader MW-R7B - 13.56 MHz - black
TheRFIDcardandtransponder reader designed forwallmount applications. Operates at frequency of 13.56 MHz. It is compatible with the following standards: MIFARE Classis, MIFARE Plus, MIFARE Ultralight C, MIFARE DESFire, ICODE SLI and iClass. The reader has 3 GPIO pins. It is also equipped with a touch button and built-in signaling LED. The housing version isblack.
RFID reader MW-R7B - 13,56 MHz - black.
The set includes assembly studs.
The specification of RFID reader MW-R7
- Supply voltage: from 8 V to 15 V
- Maximum supply current 120 mA
- Average current consumption: 25 mA
- Rated RF Frequency: 13.56 MHz
- Supported standards: MIFARE Classis, MIFARE Plus, MIFARE Ultralight C, MIFARE DESFire, ICODE SLI, iClass
- Supported communication interfaces: RS232, RS485, 1-Wire, WIEGAND and CAN 2.0B
- Operation with Netronix and MODBUS-RTU protocol in RS232/RS485 interface mode
- Number of GPIO pins: 3
- Card and transponder reading distance: up to 8 cm
- Degree of protection: IP54
- Front button type: capacitive
- Built-in buzzer, antenna, RGB LED
- Dimensions: 83 x 44 x 14 mm
Leads description
Reader has eight pins in form of wires with stripped insulation, placed on back side of casing. Below you can find description of each connection.
| Leads description of MW-R7B reader | |||
|---|---|---|---|
| Cable color | Name | Function | |
| Red | VCC | Power supply | |
| Blue | GND | GND | |
| White | Anti-collision | Lead for connecting readers working close to each other | |
| Brown | PinOUT | Any purpose output | |
| Green | PinINTERFACE1 | Serial interface line: RS232_TX, RS485_B, CAN_H, WIEGAND0, 1WIRE | |
| Yellow | PinINTERFACE2 | Serial interface line: RS232_RX, RS485_A, CAN_L, WIEGAND1 | |
| Gray | PinIN0 | Any purpose input | |
| Pink | Pink PinIN1 | Any purpose input | |
Useful links |
