- EOL
|
Attention! The sale of the product has been completed. Check otherdevices in this category. |
Specification
- Power supply voltage: 220V-240V
- Power consumption: 720W
- LED displays
- Microprocessor control of parameters: temperature, blowing power, operating time
- ESD safe system
-
Hotair soldering iron:
- Smooth temperature control over the entire range: from 100 to 480°C
- Temperature stability: +/-1oC
- Hot air temperature LED display
- Air flow rate: up to 120 l/min
- Airflow: fan
- Mode of operation: Automatic / Manual
- Protection against too high a temperature
-
The main soldering iron:
- Temperature range: 200-480°C
- Temperature stability: +/-1oC
- Sleep mode
- Potential to ground below 2mV
- Resistance to earth less than 2ohm
Description
The WEP 852D+SE is a 2-in-1 device: hot air blast and a 60W main soldering station. LED displays indicate the set temperature. The ESD Safe system protects the soldered parts from damage.
The hotair blow is equipped with a ceramic heating element that heats up quickly and evenly. The heater is made of hard alloys, which allow a long time without deformation. This increases the stability of the work and extends the life.
A micro-contact is placed in the hot air flask holder. When the flask is put down in automatic mode, it will move into a waiting state by cooling the heating element. The air supply is then switched off.
Soldering station WEP 862BD+ is used for soldering and brazing electronic components such as: SOIC, CHIP, QFP, PLCC, BGA, SMD (e.g. components in mobile phones).
Included:
- Soldering station WEP 862BD+
- Hotair flask tray
- A set of nozzles:
- round nozzle with diameter 4.4 mm 1130
- round nozzle with 8 mm diameter 1195
- round nozzle with a diameter of 9 mm 1197
- square nozzle 12x12 mm 1313
- Main flask holder with cleaning sponge
- Mainsail with mainsail T-I
- System lift gripper
- Power cord
|
First start-up
|
