The product has been discontinued. Check others products in category.
Board in the form of shield that allows you to connect the LCD screen to Raspberry Pi minicomputer 3B+/3B/2B/B+ through the tape 40 or 50 pin. The board also allows for the connection of VGA screens.
The subject of the sale is a shield with the adapter, minicomputer Raspberry Pi must be purchased separately.
Shield is working with Raspbian system without the need to install drivers. However, in order that the screen displays the picture properly, you should change the resolution in the configuration file. To do this, open the file config.txt with command:
sudo nano /boot/config.txt
and then, at the end add the following statements:
for 800x480 screens:
hdmi_timings=800 0 40 48 88 480 0 13 3 32 0 0 0 60 0 32000000 6
for screens 1024x600 and VGA:
hdmi_cvt 1024 600 60 6 0 0 0
If you connect a monitor via the VGA connector, use the jumpers, as pictured below.
- Shield for Raspberry Pi 3B+/3B/2B/B+
- Ribbon 50 pin
- Adapter with connectors 40 and 50 pin
- Screws and spacers