- EOL
Attention! The product has been discontinued. Check other products in category. |
Product description: Lanberg natural gas and coal gas sensor SR-1007 230 V
Lanberg's high-quality electrochemicalgassensor in white is designed todetectnatural and coal gas. The device is very sensitive to gas leaks in buildings, e.g. in the kitchen or boiler room. It is poweredfrom 230 V to 250 V, power consumption is 2.1 W. The device has a 1.35 m long cablewitha flat mains plug. The sensor emits a linear sound signal of approx. 85 dB when it detects gas that exceeds the permitted level. This notifies all users of the possibility of a leak.
Before use, please read the product's instruction manual included with the kit. |
Lanberg SR-1007 230 V natural gas and coal gas sensor.
Safe installation
The sensor is installed in different ways, depending on the gas detected:
- Naturalgas: the sensor is mounted on the wall at a distance of at least 50 cm from the ceiling and 1.5 metres from the gas source (natural gas is lighter than air).
- Compressed natural gas or coal gas: the sensor is mounted on the wall at a distance of approximately 30 cm (or less) from the ground and at a distance of 1.5 m from the LPG source (the gas components are propane or butane, i.e. gases heavier than air).
Set contents
-
Lanberg gas sensor SR-1007
- Mounting screws and studs
- Operating instructions
Lanberg natural gas and coal gas sensor SR-1007 230 V.
Gas sensor specification
- Manufacturer: Lanberg
- Colour: white
- Supply voltage: 230 V to 250 V / 50-60 Hz
- Power consumption: 2,1 W
- Operating temperature: 0°C to +50°C
- Permissible humidity: 10% to 95% RH
- Compliance with EU standard: EN 50194-1:2009
- Alarming gas level: 2500 PPM (+/- 1500 PPM)
- Volume / effective alarm signal range: 85 dB/1 m
- Cable length: 1,35 m
- Product dimensions: 105 x 72 x 28 mm
Useful links |