- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
Set includes small OLED MicroView display compatible with Arduino along with a set of elements introducing to the world of programmable electronic systems. In addition to the display and the breadboard with the connecting cables, the set includes also the LEDs, resistors, sensors, motor and servo.
The set consists of:
| L. p. | Photo | Description |
|---|---|---|
| 1 |  |
MicroView - OLED display compatible with Arduino with built-in Atmega328P microcontroller and uploaded Arduino Uno bootloader. The module can display messages, sensor data or serve as part of the user interface. |
| 2 |  |
MicroView - USB programmer for the MicroView OLED display. The device is equipped with both male and female connectors, thanks to this, the board can be directly attached or be connected using wires. |
| 3 |  |
400 fields breadboard. |
| 4 |  |
8-bit SN74HC595 shift register. |
| 5 |  |
A set of 5 mm LEDs (20 pieces) - 10 PCs. of red and 10 psc. of yellow elements. |
| 6 |  |
Tact switch button of 12 mm - used as an element of inputting data to the Arduino module. |
| 7 |  |
The BC337 NPN transistor. |
| 8 |  |
A set of resistors (40 PCs) - 20 PCs of elements with values of 10 kΩ and 330 Ω. |
| 9 |  |
1N4148 signal diode. |
| 10 |  |
DC motor with gear. |
| 11 |  |
JZC-11F traditional relay. |
| 12 |  |
A0090 micro servo with horns - parameter-similar to the HS-55. |
| 13 |  |
USB A extension cable. |
| 14 |  |
Deflection sensor 73 x 6.3 mm - when you bend, the sensor increases its resistance. |
| 15 |  |
TMP36 temperature sensor - analog thermometer powered with a voltage from 2.7 to 5.5 V in temperatures from -40 °C to +125 °C, details in the documentation. |
| 16 |  |
1 photo resistor - 10k - sensor for measuring the intensity of the incident light, allows, for example, to detect if the room is dark or light. |
| 17 |  |
Buzzer with generator - when powered with 5 volts, a simple sound generator. |
| 18 |  |
10k rotary potentiometer - similarly to buttons, connected to the analog pins, can serve as a user interface's element - simple knob. |
| 19 |  |
The connecting wires, 30 pcs. male-to-male - male with length of 18 cm - enables the creation of the connections on the breadboard and between board and Arduino. |
| 20 |  |
RGB LED with common cathode - LED with four pins illuminating in all colors. |
Useful links |
