- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
A device for transmitting and receiving radio waves in the range from 300 MHz to 3.8 GHz designed for research and development of radio signals. The device works on the basis of the SDR (Software Defined Radio), that is, radio communication performed by using the software in the form of digital signals. Due to the flexibility of hardware and software, bladeRF can be configured as picocell GSM and LTE, the GPS receiver, an ATSC transmitter or customer of wi-fi / Bluetooth without the use of expansion cards.
Specification
- Powered by USB 3.0
- Frequency range: 300 MHz to 3.8 GHz
- Sampling in Full-duplex mode 12-bit
- The sampling rate up to 40 msps
- Factory calibrated VCTCXO in the range from 1 Hz to 38.4 MHz
- The expansion port GPIO
- SPI flash
- Extended transmit frequency using tile XB-200
- Typical power (TX): +6 dBm
- Independent sampling RX/TX 12-bit / 40 msps
- The possibility of receiving channels 28 MHz, full-duplex
- Factory-calibrated 16-bit DAC to 38.4 MHz VCTCXO
- CPU: ARM9
- Clock signal: 200 MHz
- Memory: SRAM: 512 KB
- System: 40KLE Altera Cyclone 4 E FPGA (JTAG port)
- 2x2 MIMO is configured by the SMB wire, expandable to 4x4
- Compatible with GNU Radio, Linux, Windows, Mac
- Connector for external antenna: SMA female
- Includes:
- Module bladeRF
- USB 3.0 cable
- 2x SMA cable
The set does not include antennas, they can be purchased separately.
Useful links |
