- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
A small module with a microcontroller with ARM Cortex M0 known fromArduino M0. Feather is designed for portable projects. Thanks to the microUSB connector and uploaded bootloader, the module can be programmed directly fromthe Arduino IDE environment. Board has a small size (51 x 23 x 8 mm) and can be powered by voltage from USB port or rechargeable battery3,7 V LiPol. The module has built-in Bluetooth BLE4.1 so it can become the control center of a wireless network.
Mobile projects
Controller Feather is designed for mobile projects. Thanks to the integrated connector, it is possible to power it from the rechargeable LiPol battery 3.7 V. The battery voltage was led through an analog pin, so you can constantly monitor the state of charge of the lipol. Also available is powering from the microUSB port.
Programming (Arduino IDE)
The module can be programmed using the Arduino IDE. For this, you will need to configure the software in a way provided by the manufacturer and connect the board using the microUSB cable.The settings of the Arduino IDE are available on the website of the manufacturer.
|
The manufacturer also provides software for smartphones to communicate with the module: |
Specification
- Supply voltage: lipol 3.7 V or USB 5 V slot
- ATSAMD21G18 ARM Cortex M0 3.3 V microcontroller:
- Flash memory: 256 KB
- SRAM: 32 KB
- Clock frequency: internal oscillator 48 MHz
- Built-in Bluetooth BLE 4.1
- Driver: Bluetooth Nordic nRF51822 system
- Installed Arduino bootloader
- Works with a modified version of theArduino IDE
- ConnectormicroUSBfor programming, in our offer, you will find the necessary wire
- Installed voltage regulator 3.3 V with current delivery up to 500 mA
- Power supply from USB port or with a lipol battery 3.7 V
- 20 GPIO pins
- 8 PWM pins
- 10 analog inputs (one for the battery voltage measurement)
- Interfaces: UART, I2C, SPI
- Built-in lipol charging module 100 mA with LED indicator, which informs about the status
- LED for pin 13
- The reset button
- Included are goldpin strips for self-soldering
- Dimensions: 51 x 23 x 8 mm
- Weight: approx 5.7 g
Useful links |
