- EOL
Attention! The product has been discontinued. Check others products incategory. |
Description
Inductive, digital proximity sensor with a cable with the length of 100 cm with nuts to facilitate the mounting. It detects the metal at a distance of up to 8 mm. It is powered with the voltage from 6 V to 36 V. The object detection is indicated through the occurrence of a low status at the output (black wire) and the turning on of the red led. By default, at the output read can be a high status with the value closed to the supply voltage.
Specification
- Supply voltage: 6 V to 36 V
- Current consumption: 10 mA
- Measuring range, adjustable: from 8 mm
- Output signal: digital 300 mA
- Output status: by default in the high status, when an object is detected, it goes into a low status.
- Detectable object: metal
- Type: NPN NO (generally open)
- The LED indicating the detection of the object
- Response time: below 2 ms
- Operating temperature: -25°C to +75°C
- Diameter: 18 mm
- Sensor's length: 70 mm
Connection
- Wire - redorbrown- supply voltage - V 5
- Wire- greenorblue- ground - GND
- Wire -yellowor black- digital output - OUT
- there is no object - high status
- the object detection - low status
The product is compatible with Arduino For proper operation, it is sufficient to connect power from 6 V to 36 V and the sensor's output to any digital Arduino pin. Reading is done through a standard function digitalRead(number_of_pin). |