- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
The module contains two resonators: 44 kHz and 48 kHz. This allows you to transfer higher sound quality to the DAC. Kali has a very small deviation of the jitter. The resulting sound is much cleaner, more three-dimensional. You can hear the clear sounds, words or tools that previously have been impossible to hear. It is working with minicomputers SparkyandRaspberry Pi.
|
The device does not work properly if the D/A converter is connected as a Master. D/A converter should be connected as Slave. We recommend a module from our range:Piano 2.1. |
Specification
- It contains the FPGA with a FIFO queue
- Two oscillators: 44 and 48 MHz
- The input data of I2S: 44.1 kHz, 48 kHz, 882 kHz, 96 kHz, 176,4 kHz, 192 kHz: 16-bit, 24-bit and 32-bit
- Output data of I2S: 44.1 kHz, 48 kHz, 882 kHz, 96 kHz, 176,4 kHz, 192 kHz: 16-bit, 24-bit and 32-bit
- FIFO memory: 4 MB
- It can work with external oscillators to improve performance
- Indicating LEDs (Power, Full, Lock, Empty, Sample Rate, Mclk)
- DC connector: supply voltage 5 V / 3 A with filtered circuit
- The possibility of multifrequency I2S output throughout the whole range
- Automatic change of frequency depending on input signal
- Very fast and low propagation delays
- Voltage regulators of ultra low noise for optimal performance
- Built-in EEPROM for auto-configuration (with write protection)
- Module dimensions: 78 x 58 x 24 mm
- Weight: 120 g
Useful links |
